22
installation
location
When selecting a position for your unit you should make sure the
floor is flat and firm, and the room is well ventilated. Avoid locating
your unit near a heat source, e.g. cooker, boiler or radiator. Also
avoid direct sunlight as it may increase the electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to
perform properly.
This unit is not designed for use in a garage or outdoor installation.
Do not drape the unit with any covering.
When installing the unit, make sure that 10 cm of free space is left
at both sides, 10 cm to the back and 30 cm to the top of the unit.
This will allow fresh air to circulate around the unit and improve the
efficiency of the cooling process.
reversing the door swing
Tools Required:
• Phillips screwdriver
• Flat blade screwdriver
• Wrench
1. Remove the top hinge cover.
2. Remove the screws holding the top hinge using a cross slot screw-
driver.
Two screws
T
op hinge
cover
Summary of Contents for RMC215NEWWY1
