Note:
The crescent-shaped groove on the
front of the compressor can be used to
support the Nebulizer during treatments,
Fig. 9
.
7) Once the treatment is
complete, press the
POWER switch to the
“off” position and
unplug the power
cord from the outlet.
IMPORTANT!
The Compressor will automatically shut off if it
becomes overheated. If/when this happens,
immediately:
1) Press the POWER switch to the “off”
position.
2) Unplug the power cord from the outlet.
3) Allow the motor to cool for 30 minutes.
Before restarting the unit, make sure that the
air vents are not obstructed.
After Every Use
1) Unplug the unit from the power source.
2) Allow the unit to completely cool.
3) Carefully detach the air tubing from the
Nebulizer and discard any remaining
medication.
4) Follow the cleaning procedures provided in
this guidebook.
cup. (The cone shaped stem inside the
medicine cup inserts into the cone shaped
green jet),
Fig. 4
.
5) Add the prescribed amount of
medication to the medication
cup,
Fig. 5
.
6) Reassemble the Nebulizer by
carefully twisting the medicine
cup and cover together.
Make sure that the two
parts fit securely.
Operating Your
Nebulizer
Note:
The Nebulizer is
operable up to a 45
o
angle.
1) Attach one end of the air tube connector to
the air stem,
Fig. 6
.
2) Carefully attach the
opposite end of the air
tubing connector to the
stem at the base of the
Nebulizer,
Fig. 7
.
3) Attach the angled
mouthpiece or
optional mask
to the top of the
Nebulizer,
Fig. 8.
If using the
optional tee
adapter set,
a) Attach the
tee adapter
to the top
of the Nebulizer,
b) Connect one end of the tee adapter
to the straight mouthpiece and the
other to the extension tube.
Note:
The tee adapter is not needed when
using a mask.
4) Check that the POWER switch is in the “off”
position. Plug the power cord into a main
outlet.
5) Press the POWER switch to the “on” position.
6) Start your treatment according to your
physician’s or therapist’s instructions.
5
Fig. 4
Fig. 5
Fig. 9
Fig. 6
Fig. 7
Fig. 8
