NOTE: This charger is delivered with two detachable battery
connection sets. If intending to charge using the connection set with
the battery clamps, first disconnect and remove the battery from the
vehicle and place in a well ventilated area. The connection set with
the eyelets allows convenient quick connection/ disconnection of
the charger to the battery when the vehicle is garaged. The eyelets
of the other connection set can be permanently attached to the battery
posts by fixing them firmly through the holes in the posts with
galvanized bolts and nuts. In the case of solid posts have a
professional service agent fix the eyelets to the posts, for example
using suitable galvanized self-tapping screws. The eyelet on the lead
with the RED lug must be fixed to the positive pole (marked Pos
or P or+ and often red) and the other lug to the negative pole (Neg or
N or -and often black). Ensure that the 2-pin connector is situated
away from the battery and restrained so as not to come into contact
with any moving part of the vehicle. Prevent entry of damp and dirt to
the 2-pin connector. If in any doubt concerning any of the above
instructions, consult a professional service agent for assistance.
2
The Intelligent Battery Driver is a charger based on microprocessor
for all types of rechargeable 12V lead-acid batteries: filler cap types ·
all types of AGM 'MF'·valve regulated(VRLA)·GEL-electrolyte types.
For automobiles and other vehicles. DO NOT use to charge NiCci
or NiMH batteries.
TECHNICAL SPECIFICATIONS:
Input: Voltage------------100-i 20 AC or 220--260 AC. 50/60Hz
Current ----------Max. 0.5A
Output: Voltage-------------Max. 14 .4 V or 14 .7V
Cu rrent------------Max .4. OA
Battery Range: -----------2.3Ah-120Ah
IP Level
--------------1 P65
LEDS INDICATOR:
Power On :Power supply indicator
Charge: Battery being charged indicator
Reverse: Incorrect polarity indicator
Weak: Bad battery indicator
Ok: Battery being charged fully
Recovery: Recovery in progress indicator
3
