SYNERGIC AND BASIC MIG OPERATION
Synergic vs. Manual Setup and Operation
How Synergic MIG operates:
The Synergic function of the SYN. MIG component allows the user to only need to use the wire
feed speed control to make the unit operate. The welder is programmed to automatically adjust the
voltage based off the users input of wire diameter, and filler metal type when the wire speed is
increased or decreased by turning the wire speed adjustment knob. While in the Synergic mode, the user
“
”
can make manual adjustment to
fine tune
the voltage if he chooses by turning the voltage up or
down after adjusting the wire feed speed. If the wire speed is readjusted after manual adjustment to
voltage is made, the unit defaults to the synergic mode again, and voltage is once again adjusted
automatically. The welder may be used in full Manual mode, with independent control of the wire feed
speed by simply selecting MIG on the wire diameter selector. Settings will not be saved when the unit
cycles off and back on and will default to factory settings. If stepping away briefly it is best to keep the
unit on, or the settings will not remember the last settings if it is turned off.
10
working piece
welding gun
front panel.
GAS
SIDE VIEW
front panel.
working piece
welding gun
NO GAS
SIDE VIEW
