32
32
11
32
11
11
31
29
30
Fig. 4a
Fig. 4b
To assemble the front rail & rip fence
> Push the five hex bolts M6 x 16 [32] onto the slot of the front rail [11] from the
side of the front rail in turns.
> Insert the hex bolts M6 x 16 [32] through the holes on the working table, left and
right extension tables, then put the flat washers 6 [29], spring washers 6 [30] and
loosely tighten on the hex nuts M6 [31] as shown in the Fig. 4b.
> Reinstall the table insert [17].
Before you start
MSTS1500-A
by
MacAllister
Getting
started...
25
EN
NOTE:
The riving kinfe must be aligned with saw blade after
finished and the distance between the outside edge of the saw
blade and the riving knife must be three to eight millimetres. If
not, please contact with your dealer, because riving knife of this
table saw not need be adjusted.
