Fig. 11
Bevel locking handle
The bevel locking handle [10] locks the blade in the desired tilting angle. To loosen
turn it anti-clockwise. When setting the angle of the cut fully loosen it.
Before turning the table saw ON, be sure it is securely tightened so that the blade
will not shift during the table saw operation. (Fig. 11)
Bevel adjusting handwheel
The saw blade can be adjusted easily between 0° and 45°.
The bevel adjusting handwheel [8] is used to tilt the blade for bevel cutting.
Loosen the bevel locking handle [10], then slide the bevel adjusting handwheel
to the right to tilt the blade to the left and slide it to the left to tilt the blade to the
right. (See Fig. 11).
8
10
6
36
Product functions
MSTS1500-A
by
MacAllister
In
more
detail…
EN
Warning: Risk of injury!
In order to avoid injury and prevent accidental start-up when the
overload reset switch is pushed, On/Off switch should be in the
OFF position, and the power cord should be unplugged from the
outlet while the saw is cooling down. Overheating may be caused
by an under-sized extension cord, an extension cord that is too
long, misaligned parts, or a dull blade. inspect the saw for proper
set-up before using it again.
Warning: Risk of injury!
Always check the bevel locking handle before working. A loose
bevel locking handle may cause serious injury.
