MCSWP2000S-2
09
EN
Getting
started...
Additional safety warnings
1. The product should be supplied via a residual
current device (RCD) with a tripping current of
not more than 30 mA.
2. Position the cord so that it will not be caught on
branches and the like, during cutting.
3. It is recommended that first-time user should, as
a minimum practice, cutting logs on a saw-horse
or cradle.
Clothing and protective equipment
1. Do secure long hair so that it is above shoulder
level.
2. Do not wear loose fitting clothing or jewellery as
this could be drawn into the engine, catch the
chain or undergrowth.
3. Use the following safety clothing and protective
equipment when operating the product:
- Helmet with visor and neck guard - (EN397
compliant),
- Hearing protectors,
- Breathing mask,
- Gloves with approved saw protection (compliant
to EN 381-4, EN 381-7, EN420:1, EN 388 Class
0),
- Protective leggings with approved saw protection
(compliant to EN 381-5, EN 340 Class 1),
- Steel toe cap boots with approved saw protection
(compliant to EN 345-2 Class 2),
- First Aid kit in case of injury.
Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as well as
wear personal protective equipment.
Take the following points into account to minimise
the vibration and noise exposure risks:
1. Only use the product as intended by its design
Safety information
