29
MGSP18LI
par Mac Allister
In
more
detail...
EN
Operation
Cutting with spiked bracket
1. Place the bracket onto the workpiece.
2. Ensure the blade is not touching the workpiece and switch the
product on as described.
3. Wait until the saw blade runs at full speed.
4. Slowly lower the saw blade into the workpiece applying light
pressure downward (Fig. 17).
Cutting without spiked bracket
1. Remove the bracket from the product.
2. Ensure the blade is not touching the workpiece and switch the
product on as described.
3. Wait until the saw blade runs at full speed.
4. Move the product in a swinging motion so the saw blade cuts
through the workpiece with an even feed (Fig. 18).
Fig. 17
Fig. 18
After use
1. Switch the product off, remove the battery back and let it cool
down.
2. Check, clean and store the product as described below.
Summary of Contents for MGSP18LI
Page 39: ......
