06
MIS2400
by MacAllister
Getting
started...
EN
Safety information
Safety warnings
9. When feeding material into the product be extremely
careful that pieces of metal, rocks, bottles, cans or
other foreign objects are not included.
10. If the cutting mechanism strikes any foreign objects or
if the product should start making any unusual noise
or vibration, immediately shut off the power source
and allow the product to stop. Disconnect the product
from the supply and take the following steps before
restarting and operating the product:
-inspect for damage;
-replace or repair any damaged parts;
-check for and tighten any loose parts.
11. Do not allow processed material to build up in the
discharge zone; this may prevent proper discharge
and can result in kickback of material through the feed
intake opening.
12. If the product becomes clogged, shut-off the power
source and disconnect the product from supply before
cleaning debris.
13. Never operate the product with defective guards or
shields, or without safety devices, for example debris
collector in place.
14. Keep the power source clean of debris and other
accumulations to prevent damage to the power source
or possible fire.
15. Do not transport this product while the power source
is running.
16. Stop the product, and remove plug from the socket.
Make sure that all moving parts have come to a
complete stop
-whenever you leave the product,
-before clearing blockages or unclogging chute,
-before checking, cleaning or working on the product,
MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 6
MNL_MIS2400_2400W Impact Shredder_GB_V2_220321.indd 6
2022/3/21 5:46 PM
2022/3/21 5:46 PM
