36
Care
WARNING!
Always switch the product off, disconnect the
spark plug connector / remove the battery pack and let the
product cool down before performing inspection, maintenance
and cleaning work!
DO NOT touch a rotating blade.
• Keep the product clean. Remove debris from it after each use and before storage.
• Regular and proper cleaning will help ensure safe use and prolong the life of the product.
•
WARNING!
Only perform repairs and maintenance work
according to these instructions! All further works must be
Product maintenance
Before and after each use, check the product and accessories (or attachments) for wear and damage. If required, exchange them
for new ones as described in this instruction manual. Observe the technical requirements.
WARNING!
It requires to tip the product when perform the
maintenance, therefore the fuel tank must be empty or fuel
NOTE:
Always empty the fuel tank and keep the spark plug
upside. Otherwise the fuel or engine oil will contaminate the
37
Underbody and cutting device
WARNING!
Wear protective gloves when working on the
cutting device and close to it! Use proper tools to remove
debris, e. g. a wooden stick! Never use your bare hands!
Always use original spare parts for replacement. The cutting
263001465. Do not attach any other type of cutting device!
The replacement of the cutting device should be done by
an experienced user! Rework or sharpening blades is not
recommended unless it is done by a repair service or a
NOTE:
We strongly recommend jacking the product up when
performing inspection and work on the cutting device. Avoid
tilting the product in order to prevent fuel and oil leakages.
• Keep the underbody and cutting device (27) clean and free of debris. Remove clippings from the rear discharge chute (25).
• Check all nuts and bolts periodically for tightness before operation. After prolonged use, especially in sandy soil conditions, the
cutting device will become worn and lose some of the original shape.
should be replaced.
• Keep the cutting device (27) sharp to ensure a good cutting performance. Replace a worn or damaged cutting device with a new
•
device (27), support (27d), ring (27c) and pin (27b) (Fig. 33).
•
NOTE:
Replace this cutting device after 50 hours mowing or
2 years whichever is sooner regardless of condition. If the
cutting device is cracked or damaged, you must immediately
replace it with a new one.
• Lubricate the cutting device (27) after each use to prolong the life span of cutting device and product. Apply light machine oil along
the edge of the cutting device.
Tighten the hex bolt clockwise with 40 Nm min,
50 Nm max. to ensure safe operation of your product.
