MLM1834-Li
by MacAllister
Getting
started...
Before you start
EN
17
1. Unfold and loosen the clamp levers (5) anti-clockwise on the lower handle
bars (6), but do not remove them (Fig.1, step 1).
2. Grasp the lower handle bars (6) and unfold them from storage position to
work position (Fig. 1, step 2).
3. Secure the lower handle bars (6) by folding up the clamp levers (5) towards
the lower handle bars (6). If the clamp lever (5) cannot be folded, loosen
it and fold again. If it is too loose, tighten it by turning the clamp lever (5)
clockwise (Fig. 2).
5
5
6
6
8
1.
2.
1.
2.
Fig. 1
6
6
8
5
5 8a
6a
Fig. 2
NOTE:
For first assembly, secure the lower handle bars (6) with the
clamp levers (5) in the middle position of the tilt adjustment mechanism
by aligning the indication line (6a) with the indicator (8a) of the transport
handle (8). Ensure the lower handle bars (6) are assembled on the
same height level on both side.
4. Hold the upper handle bar (4) with the safety switch button (2) facing upwards.
Align the mounting holes of the upper handle bar (4) and the lower handle
bars (6) (Fig. 3, step 1).
5. Pass the mounting bolt (5b) through the mounting holes to the end (Fig. 3,
step 2).
6. Attach the washer (5a) and screw in the clamp lever (5) clockwise through
the thread of the mounting bolt (5b), lock it by folding up the clamp lever
(5) towards the handle. If clamp lever (5) cannot be folded, loosen it and
fold again. If it is too loose, tighten it by swinging the clamp lever (5) (Fig.2,
step 3).
7. Do it again on the other side. Make sure that the interconnection cord (18) run
on the upper side of the handle bars (4, 6).
NOTE:
There are two handle height positions in the upper handle bar
(4). Ensure the upper handle bar (4) is assembled on the same height
level on both lower handle bars (5).
MNL_MLM1834-Li_18V 34cm Lawnmower_IM_GB_V1_211009.indd 17
10/9/21 10:58 AM
