MACTOOLS.COM
10
3. Remove accessory, connect the tool to an air source, then cover the
exhaust end with a towel and run tool for 2 to 3 seconds.
Fig. 4
To lubricate internal mechanism:
Locate the grease fi tting on the back of the tool (fi g. 4). Inject 4 grams
of Mac Tools approved impact grease into the fi tting every 3-5 months
depending on use. Use recommended grease gun nozzle tip (fi g. 5) on
grease fi tting, smaller or sharp nozzle will damage grease fi tting ball bearing.
3.0mm
3.0mm
1.0mm
GREASE NOZZLE TIP
Fig. 5
WARNING
:
Keep out of the reach of children. If air tool oil is
ingested, do not induce vomiting, call a doctor immediately.
WARNING
:
Any excess oil in the tool is immediately expelled from the
exhaust port. Always direct exhaust port away from people or objects.
NOTE: Check the speed and make a simple check of the vibration level
after each service.
Storage:
The air tool must be lubricated before storing. Follow the
“Lubrication” instruction with exception of step 3.
Always use an air line lubricator with this tool. Do not over-oil and do not use heavy grade oil as stalling and low
performance may result.
PLACING TOOL IN SERVICE
An air fi lter unit should be
placed between air compressor
and air lubricator to promote
clean air supply to the impact
wrench. Water, dirt, and scale
can damage the impact wrench.
EMERGENCY
GATE VALVE
Fig. 6
Fig. 7
1/4" NPT HIGH FLOW FITTING
AIR HOSE 3/8" (10 mm) I.D. MIN.
