JSTLP1100 2
6/3/15
WARNINg INFORMATION
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING PROCEDURES, SAFETY WARNINGS
AND MAINTENANCE REQUIREMENTS. SAVE THESE INSTRUCTIONS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using this jack. It is also the responsibility of the jack owner to keep this
manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not legible, contact Mac Tools for replacements. If
the operator is not fluent in English, the product and safety instructions shall be read to and discussed with the operator in the operator's native language by
the purchaser/owner or his designee, making sure that the operator comprehends its contents.
This product is intended only for use in the removal, repair, and installation of vehicle transmissions. Do not use or modify this product for any other purpose
than that for which it was designed without consulting the manufacturer's authorized representative. The use of portable automotive lifting devices are subject
to certain hazards that cannot be prevented by mechanical means, but only by the exercise of intelligence, care, and common sense. It is therefore essential
to have owners and personnel involved in the use and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of
the equipment and its proper use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before operating this device
• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid, or unstable due to loose or missing
components. Make corrections before using
• Consult the vehicle manufacturer for the transmission’s center of balance
• Secure the transmission to the jack’s saddle with the anchorage restraint system provided before raising or lowering the transmission
• Center load on saddle. Be sure setup is stable before working on vehicle
• Support the engine with a stand before unbolting the transmission from the engine
• Wear eye protection that meets ANSI Z87.1 and OSHA standards (users and bystanders)
• Do not use jack beyond its rated capacity. Do not shock load
• Use only on a hard level surface
• Adequately support the vehicle before starting repairs
• Use of this product is limited to the removal, installation and transportation in the lowered position, of transmissions, transfer cases and transaxles
• Do not use any adapters unless approved or supplied by Mac Tools
• Always lower the jack slowly and carefully
• Do not use or modify the product for any other purpose than that for which it was designed without consulting the manufacturer’s authorized representative.
• This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Wash hands
thoroughly after handling
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS, MAINTENANCE INSTRUCTIONS
and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS could cause accidents resulting in serious or fatal personal
injury and/or property damage.
WARNING:
Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
WARNING
WARNING
WARNING
WARNING
THIS INSTRUCTION MANUAL USES THE FOLLOWING SYMBOLS AND DEFINITIONS TO ALERT YOU TO HAZARDOUS CONDITIONS WHICH MAY CREATE A RISK
OF PERSONAL INJURY AND/OR PROPERTY DAMAGE.
