800.MACTOOLS
5
• Use the power tool, accessories and tool bits, etc. in accordance with these instructions, taking into account
the working conditions and the work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
• For multiple hazards, read and understand the safety instructions before installing, operating, repairing,
maintaining, changing accessories on, or working near the saw. Failure to do so can result in serious bodily
injury.
• Ensure safe clamping of the blade to the saw.
• NEVER operate the tool unless the guard is in place, in good condition and is correctly mounted; inspect the
guard regularly.
• Ensure that sparks and debris resulting from use do not create a hazard.
• The pneumatic tool must be fitted and connected to the compressed air network via quick disconnects to
facilitate shutdown in the event of danger.
• When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts
be separated by material so that they can be recycled.
• Always turn off the air supply and disconnect the air supply hose before installing, removing or adjusting any
accessory on this tool, or before performing any maintenance on this tool.
• Do not use damaged, frayed or deteriorated air hoses and fittings. Do not abuse hoses or connectors.
• Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet fuel.
• Do not remove any labels. Replace any damaged label.
• Do not use the tool if the trigger does not turn the tool on or off.
• Do not lock, tape or wire the "on/off" safety lever in the "on" position, as the lever must be free to return to
the "off" position when released.
• Be sure all hoses and fittings are the correct size and are tightly secured.
• Always use clean, dry air at 90 psig (6.2 bar) maximum air pressure. Dust, corrosive fumes and/or excessive
moisture can ruin the motor of an air tool.
• The use of a hose whip is recommended. A coupler connected directly to the air inlet increases tool bulk and
decreases tool maneuverability.
• For maximum performance, the coupler on the wall should be the next size larger than the coupler used on
the tool. The coupler closest to the tool should not be less than the proper air supply hose size.
• Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the
work by hand or against the body is unstable and can lead to loss of control, resulting in injury to yourself.
• Do not alter any part/component/accessory of this tool in any way.
• When not in use, disconnect tool from air supply to prevent accidental or unauthorized use in the absence of
the operator.
• Mesh air strainer at air inlet occasionally becomes clogged with debris, blocking air supply, and decreasing
the tool's performance. If this occurs the mesh air strainer needs to to be cleaned.
• Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
• Place the tool on the work surface before starting the tool. Do not point or indulge in any horseplay with this
tool.
• lnspect the cutting blade before use. Do not use cutting blades which (possibly) have been dropped or which
are chipped, cracked or otherwise defective.
• Ensure that the cutting blade is correctly mounted and tightened before use and run the saw at no-load
speed for at least 1 min in a safe position; stop immediately if considerable vibration or other defects are
detected and determine the cause of these defects.
• When cutting off, the workpiece shall be supported such that the slot is kept at constant or increasing width during
the complete operation.
• If the blade becomes jammed in a cut slot, shut off the saw and ease the bit free. Check that the blade is still
correctly secured and not damaged before continuing the operation.
4) SERVICE
• Tool service must be performed by qualified repair personnel, using only Mac Tools authorized, identical replacement
parts. Use only lubricants recommended by Mac Tools.
