OM-154 500 Page 12
Wire Drive/Gun Trouble
Remedy
Section
Electrode wire feeding stops during
welding.
Straighten gun cable and/or replace damaged parts.
4-4
Adjust drive roll pressure.
2-6
Readjust hub tension.
2-6
Replace contact tube if blocked.
4-4
Clean or replace wire inlet guide or liner if dirty or plugged.
4-3, 4-4
Replace drive roll or pressure bearing if worn or slipping.
4-3
Secure gun trigger plug in receptacle or repair leads, or replace trig-
ger switch.
2-4
Check and replace F1.
4-2
Check and clear any restrictions at drive assembly and liner.
4-3, 4-4
Have nearest Factory Authorized Service Station/Service Distribu-
tor check drive motor.
– –
SECTION 5 – ELECTRICAL DIAGRAMS
SB-163 084
Figure 5-1. Circuit Diagram For Welding Power Source
Summary of Contents for MW150K
Page 16: ...OM 154 500 Page 13 Figure 5 2 Wiring Diagram For Welding Power Source SC 163 085...
Page 19: ...Notes...
Page 20: ......
