Mac Victor 2.0 Installation Operation Manual 042408.pdf - © 2008 Mac Victor Power, LLC.
Page 3 of 23
1 - IMPORTANT SAFETY INSTRUCTIONS
1.1 Save these Instructions
This manual contains important instructions and specifications for the Mac Victor 2.0 that should be
followed during installation and maintenance.
CAUTION: Risk of Personal Injury and Equipment Damage.
Before attempting to install and power up the Mac Victor 2.0, carefully read
this manual. Keep this manual with the Mac Victor 2.0 for future references.
All service work must be done by qualified personnel. Do not attempt to
service the Mac Victor 2.0 unless you have had proper training.
WARNING: Risk of Electrical Shock and Personal Injury. Opening or
removing covers risk the exposure to dangerous voltages!
While every effort has been made to ensure the completeness and accuracy of this manual,
Mac Victor Power, LLC and THOR SYSTEMS, Inc. accept no responsibility or liability for
any loss or damage resulting from the use of the information contained in this document.
This complete document shall not be copied or reproduced without the written permission
of Mac Victor Power, LLC. Due to technical improvements, some of the information
contained in this manual may be changed without notice.
1.2 General
WARNING: RISK OF ELECTRICAL SHOCK AND PERSONAL INJURY.
More than one Disconnect Switch may be required to de-energize the equipment before
servicing. Service is to be performed by qualified personnel only!
See Installation Instructions before connecting to the supply.
The Mac Victor 2.0 provides plug and receptacle interfacing with selected models of
Uninterruptible Power Supplies (hereafter UPS) manufactured by others. See the
accompanying UPS Installation Instructions before connecting to the supply. All UPS that are
used must be “Mac Victor 2.0 Compatible UPS”. (See Section 7.2 for list of Compatible UPS)
All UPS units have internal batteries as part of the product package. Dangerous voltages may
still be present even when all external voltage sources have been de-energized.
The UPS should be bypassed, turned off and disconnected during maintenance or service work.
1.3 Installation
The Mac Victor 2.0 base unit should be installed by a licensed electrical contractor.
The UPS can be installed and started up by qualified office technical personnel.
To reduce the risk of electric shock, install the Mac Victor 2.0 and the UPS in a temperature
and humidity controlled indoor area free of conductive contaminants.
Ambient temperature must not exceed 30ºC (86ºF). Optimal battery life of peripheral UPS is
also obtained if the ambient temperature does not exceed 30ºC (86ºF).
It is important that both the Mac Victor 2.0 and the UPS have adequate ventilation. Maintain
air movement around and through the units. Do not block the air vents.
Avoid installing the units in direct sunlight or near heat sources.
