Istruzioni-HCMMMTTT-09022023 (Cod.620100007 Rev.16) EsEng (USA) MAC3.doc
39
Bloqueo Cortoc.
Short Circ.Block
El inverter está
bloqueado después de
10 intentos para
restablecer el sistema
después de un corto
circuito entre fase-fase
en la bomba.
-Para eliminar el
bloqueo es necesario
llevar a cero el número
acumulado dentro del
parámetro
"Tot.CortoC.Echo" Si el
problema persiste
después de los
diferentes rearmes,
intente desconectar el
HC para restablecer la
bomba, de lo contrario
contactar con asistencia
técnica.
The drive is in lock
status after 10 reset
attempts made following
short circuit between
phase and phase on the
electro-pump.
-To remove lock
status set to zero the
number of shortcircuit
parameter
“Tot.ShortC.Done "
If the problem
persists try to reset
the drive unplugging
the pump otherwise
you have to replace
the drive, otherwise
contact technical
assistance.
Corr.Pico Alta.
High Peak curr….
La protección del
inverter ha medido un
consumo de corriente
excesivo.
-Comprobar que la
bomba se utiliza con las
condiciones prescritas
por el fabricante.
-Asegúrese de que no
hay condiciones de
fricción o de bloqueo
del impulsor
-Cambiar el valor pico
de corriente en el
parámetro 54.
The drive has measured
excessive power
consumption.
-Verify that the pump
is used under the
conditions prescribed
by its manufacturer.
-Make sure that there
are no conditions of
friction or locking of
the impeller.
-Change the pick
current value on
parameter 54.
Motor desconect.
Motor
Unconnected
La bomba no esta
conectada
-Comprobar que el
cable de alimentación
está conectado a la
bomba
The pu
mp isn’t
connected to the
inverter
-Check that the
power output cable
from the inverter is
connected to the
pump
-STANDBY
Rem.OFF
-Discapac Rem.ON
-Sys.OFF Rem.ON
-Discapac
Rem.OFF
-Sys.OFF
Rem.OFF
-Activo Rem.ON
-Sys.ON Rem.ON
- "Inicio"
ON y
el
contacto del
flotador
está abierto: la bomba
no se enciende
- "Inicio"
OFF y
el
contacto del
flotador está
cerrado: la bomba no
se enciende
- "Inicio"
OFF y
el
contacto del
flotador está
abierto: la bomba no
se enciende
- "Inicio"
ON y
el
contacto del
flotador está
cerrado: la bomba se
enciende
El inverter está
configurado para ser
activado por una boya
de nivel de mínimo para
la protección de
funcionamiento en seco
- "System Start" is
ON and contact of
float switch is open: the
inverter
doesn’t power
the pump
-"System Start" is OFF
and contact of
float switch is
closed: the
inverter
doesn’t power
the pump
-"System Start" is OFF
and contact of
float switch is open: the
inverter
doesn’t power
the pump
-"System Start" is ON
and contact of
float switch is
closed: the inverter
powers the pump
-The drive is set to be
enabled by a float
switch for dry running
protection