Software Installation
It is required to install the Login2Go and LoginEZ software first before plugging in the Macally RFID
eNetPad. You must log in with administrator privilege to perform the following installation steps.
1. Insert the included software CD into your CD-ROM drive. Installation should start automatically, if
not, please open the CD icon, locate and double click Login2Go_LoginEZ.exe to start.
2. Follow the on-screen instruction to complete the software installation. It is required to restart
machine after the installation.
3. After reboot, a new icon appears in the system tray of taskbar to indicate status of Macally
eNetPad. Red color “R” below means Login2Go is not ready.
Fig. 1
4. Plug in the Macally eNetPad into USB port. “Found New Hardware Wizard” window pops up,
follow the on-screen instruction to complete pad driver installation.
5. Now, the “R” icon in task bar will change color to green as shown below. The top pad LED
window will show blue color as well. If you don’t see these, please try to reboot the system.
6. Congratulation! You have successfully installed Login2Go and Login2EZ software, and the
Macally eNetPad.
If you accidentally plug in the eNetPad before installing software, the “Found New Hardware
Wizard” window will pop up and ask for hardware device drivers, please unplug eNetPad, follow
the step 1 through 6 above to install software first.
6
Summary of Contents for eNetPad
Page 2: ......