6
SAFETY SIGNS
The safety signs reproduced below appear on the bale carrier at the locations listed. Make sure all
safety signs are clearly legible. Signs that have become illegible should be replaced. New signs can
be purchased from your dealer or directly from the manufacturer. If new parts are installed, make
sure that the appropriate signs are in place, if applicable.
To install safety signs:
1. Be sure the installation area is clean and dry.
2. Decide on the exact location before you remove the decal backing paper.
3. Remove the smaller portion of the split backing paper.
4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is
applied.
5. Small air pockets can be smoothed out or pricked with a pin.
CABLE DRUM GUARD
1. Keep all shields in place.
2. Stop engine before leaving operator’s position to
adjust, lubricate, clean or unclog machines.
3. Wait for all movement to stop before servicing the
machine.
4. Keep hands, feet and clothing away from power
driven parts.
5. Keep all others off.
6. Make certain everyone is clear of machine before
starting engine or operation.
CAUTION
21547
CABLE DRUM GUARD
21592
HIGH PRESSURE FLUID HAZARD
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS
WILL RESULT IN SERIOUS INJURY OR DEATH
- Relieve pressure on system before repairing or adjusting.
- Wear proper hand and eye protection when
searching for leaks. Use wood or cardboard instead of
hands.
- Keep all components in good repair.
PUSHER
RUNNING PUSHER PAST AMBER REFLECTOR
WILL DAMAGE CABLE DRUM
CAUTION
21850
BALE LIFT ARM
SAFETY CHAIN MUST BE SECURED AND
LOCKED FOR TRANSPORT.
RELEASE ONLY FOR FIELD WORK.
CAUTION
21877
ROLL BAR
21841
HIGH PRESSURE FLUID HAZARD
FAILURE TO FOLLOW THESE INSTRUCTIONS
WILL RESULT IN SERIOUS INJURY OR DEATH
- Relieve pressure on system before repairing or
adjusting.
- Wear proper hand and eye protection when
searching for leaks. Use wood or cardboard
instead of hands.
- Keep all components in good repair.
WARNING
SUBFRAME
21991
Bale lift arm can cause
serious injury or death if
person becomes trapped
during arm return.
DANGER
SUBFRAME
21990
WARNING
Bale lift arm can cause
serious pinching or crushing
injury if fingers become
trapped during arm return.
LEFT OUTSIDE CARRIER
BEAM (front)
CAUTION
21860
Gross Vehicle Weight Rating
Model 1000 14,800 lbs (6700 kg)
Model 1100/2000 29,600 lbs (13400 kg)
CHAIN GUARD
WARNING
To prevent serious injury or death from moving
parts:
Close and secure guards and shields before
starting.
Keep hand, feet, hair and clothing away from
moving parts.
Disconnect and lockout power source before
adjusting or servicing.
Do not stand or climb on machine when
operating.
MOVING PART HAZARD
21878
Summary of Contents for 1000
