Form # 46584
Issue 11/06 Web Rev_01
24
OPERATOR'S STATION
Header Controls (continued)
REEL HEIGHT SWITCH (E) -
Press top of switch
to raise reel and bottom to lower. Hold switch until
reel reaches desired position.
NOTE:
For Auger Headers with Hay Conditioners
equipped with
Hydraulic Roll Opener
cylinders,
switch (E) controls the operation of these
cylinders.
HEADER HEIGHT SWITCH (F) -
Press top of
switch to raise header and bottom to lower. Hold
switch until header reaches desired position. (See
"Cut Height Indicator").
NOTE:
Handle may be rotated on lever to allow
the operator to position switches (E) and (F) for
maximum comfort. To adjust, loosen setscrews on
back of handle.
HEADER EXPRESS DOWN
(Optional)
– This dealer installed option is operated
from switch (G). To activate the express down
function, set switch (G) to “front down” position as
shown. In this mode, it is not necessary to hold
header height switch (F) to lower header fully. A
momentary touch and release of the “down” side of
switch (F) will fully retract header lift cylinders. To
stop express down function in mid-travel, touch and
release the “up” side of switch (F).
To bypass the express down function, set switch
(G) to “rear down” position. Header height switch
(F) will then operate as described at top of page.
REEL FORE-AFT CONTROLS (H) & (J)
(Optional)
– For headers with hydraulic reel fore-
aft option. Press button at (H) to move reel
forward. Press button at (J) to move reel rearward.
HEADER TILT CONTROLS (K) & (L)
(Optional)
– Press button at (K) to tilt header back
for a flatter guard angle. Press button at (L) to tilt
header forward for a steeper guard angle.
IMPORTANT:
Do not continue pressing
switches (E) or (F) after header or reel travel is
complete. If switch is held for a long period of
time, damage may occur due to overheating
electrical solenoids and/or over-heating
hydraulic oil, which is pumped through relief
valve.
E
F
K
H
J
L
REEL & HEADER HEIGHT SWITCHES
REEL FORE-AFT & HEADER TILT CONTROLS
G
HEADER EXPRESS DOWN SWITCH
Summary of Contents for 9250
Page 10: ...Form 46584 Issue 11 06 Web Rev_01 8 SAFETY SAFETY SIGNS continued...
Page 152: ......
Page 154: ......
Page 159: ...Form 46584 Issue 11 06 Header Drive Hydraulic Schematic...
