SECTION 7 MAINTENANCE AND SERVICING
Form 169000 / 169040
140
Revision D
7.8.12 Sickle Drive Timing Adjustment
Double knife A30-D and A40-D Auger Headers
require that the sickles are properly timed to
move in opposite directions.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Remove the right side sickle drive belt. Refer to
Section 7.8.10.5 Removal: RH Sickle Drive
Timing Belt: - A30-D, or Section 7.8.11.5
Removal: RH Sickle Drive Belt - A40-D.
b. Rotate LH side wobble box driven pulley (A)
clockwise until LH side sickle (B) is at the center
of the inboard stoke (moving towards center of
header).
NOTE
Center stroke is when the sickle
sections are centered between guard
points as shown.
c. Rotate right side wobble box pulley (C) counter
clockwise until right side sickle (D) is at the
center of the inboard stroke.
d. Install right side wobble box drive belt and
tension. Refer to Section 7.8.10.6 Installation:
RH Sickle Drive Belt - A30-D, or 7.8.11.6
Installation: RH Sickle Drive Belt - A40-D.
IMPORTANT
To maintain timing, wobble box driver and
driven pulleys must not rotate as the belt
is tightened.
e. Check that timing belts are properly seated in
the grooves on both driver and driven pulleys.
f. Check for correct sickle timing by rotating
driveshaft (E) slowly with the unplug wrench (F),
and observe sickles where they overlap at the
center of the header.
IMPORTANT
Sickles must move in opposite directions,
and must begin moving at exactly the
same time.
(continued next page)
F
E
RIGHT
SICKLE
LEFT
SICKLE
DIRECTION OF
MOVEMENT
SECTIONS CENTERED
BETWEEN GUARDS
B
D
A
C
