214804
25
Revision A
3
Operation
This chapter will describe the operating procedures for the A40D and A40DX SP Windrower Auger Header.
3.1
Attaching A40DX Header to M1 Series Windrowers
CAUTION
To prevent accidental movement of windrower, return ground speed lever (GSL) to Park, center steering
wheel to lock, shut off engine, and remove key.
This procedure also applies to A Series Headers equipped with the Auger Header Compatibility kit (MD #B5998) or
the A40D SP Grass Seed Auger Conversion kit (MD #B6384). Refer to your windrower operator
’
s manual for
procedures to mechanically attach an A40DX Auger Header to an M1 Series Windrower and for modifications to
the windrower hydraulic connections (if required).
IMPORTANT:
If attempting to attach an A40D Header to an M1170 or M1240 Windrower, the M1 Series Conversion kit
(MD #B5998) or the A40D SP Grass Seed Auger Conversion kit (MD #B6384) must first be installed. These kits
include a new manifold and hose bundle required for operation with an M1 Series Windrower, and effectively
converts an A40D header into an A40DX header.
Header drive hydraulic hoses and electrical harness are located on the left, cab-forward side of the windrower. To
connect the hydraulic and electrical bundle from an A40DX header to an M1 Series Windrower, follow these steps:
Figure 3.1: Hose Bundle
1.
Route header hose bundle through hose guide (A) on
header as shown.
Summary of Contents for A40-D
