214778
9
Revision A
1006363
A
Figure 2.5: Block under Cutterbar
5.
Place 150 mm (6 in.) blocks (A) under each end and center
of cutterbar, and then lower header onto blocks.
6.
Remove chain and move lifting vehicle to rear of header.
7.
Attach chain to center-link anchor on frame tube and raise
rear of header so that stand can be lowered.
1008297
A
B
Figure 2.6: Header Stand
8.
Lower header stand by pulling pin (A), lowering stand (B),
and releasing pin (A) to secure stand in place.
9.
If ground is soft, place a block under the stand.
10. Lower header onto stand.
