214778
41
Revision A
4.3
Installing Disc Segments of Outboard Reel Endshields
1017008
A
Figure 4.22: Partially Installed Reel Endshield
–
Cam
End Shown, Tail End Similar
To meet the trucking load regulations for the maximum load
width and height, two disc segments of the reel endshields (A)
may have been removed from the right reel (tail end) and left
reel (cam end). Check if reel endshields are completely installed.
If not, install the two disc segments as follows:
1017010
A
B
C
Figure 4.23: Reel Endshield
1.
Retrieve the bag of hardware removed from the center
draper support.
2.
Remove the two bolts (A) securing the disc segments to
support tabs. Retain for reinstallation later.
3.
Engage slots on disc segment (B) on endshield support
tabs (C).
1017011
A
B
C
D
E
Figure 4.24: Reel Endshield
4.
Secure the other end of the disc segment to support using
the bolt (A) that was removed earlier.
5.
Position last disc segment (B) in front of disc segment (C)
and behind disc segment (D), engage endshield support
tabs through all disc segments, and secure with two
bolts (E).
NOTE:
It may be necessary to loosen hardware and use a pry tool
to secure the last disc segment in place.
6.
Repeat procedure at the opposite side.