214778
72
Revision A
5.12
Lubricating the Header
Table 5.4 Recommended Lubricant
Specification
Description
Use
SAE multipurpose
High temperature, extreme pressure (EP2) performance with 1%
max molybdenum disulphide (NLGI Grade 2) lithium base
As required unless
otherwise specified
SAE multipurpose
High temperature, extreme pressure (EP) performance with 10%
max molybdenum disulphide (NLGI Grade 2) lithium base
Driveline slip-joints
5.12.1
Greasing Procedure
Greasing points are identified on the machine by decals showing a grease gun and grease interval in hours of operation.
Grease point layout decals are located on the header.
WARNING
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key from ignition
before leaving operator
’
s seat for any reason.
1001335
Figure 5.43: Single-Knife Header Grease Point
Layout Decal
1.
Wipe grease fitting with a clean cloth before greasing to
avoid injecting dirt and grit.
IMPORTANT:
Use clean, high-temperature, extreme-pressure grease only.
2.
Inject grease through fitting with grease gun until grease
overflows fitting (except where noted).
3.
Leave excess grease on fitting to keep out dirt.
4.
Replace any loose or broken fittings immediately.
5.
Remove and thoroughly clean any fitting that will not take
grease. Also clean lubricant passageway. Replace fitting if
necessary.
1001333
Figure 5.44: Double-Knife Header Grease Point
Layout Decal
