5. In the windrower cab, press scroll knob (A) on HPT to
display the QuickMenu system.
6. Rotate scroll knob (A) to highlight the HEADER FLOAT
symbol (B) and press scroll knob to select.
Figure 3.15: HPT Display
7. On Float Adjust page, press soft key 3 (A) to
remove
fl
oat.
Figure 3.16: HPT Display
8.
For
hydraulic
center-link
with
optional
self-alignment:
a. Press HEADER DOWN switch on the ground
speed lever (GSL) to fully retract header
lift cylinders.
b. Press REEL UP switch on the GSL to raise the
center-link until the hook is above the attachment
pin on the header.
IMPORTANT:
If the center-link is too low, it may contact
the header as the windrower approaches the
header for hookup.
Figure 3.17: Ground Speed Lever Switches
A - Reel Down
B - Reel Up
C - Header Tilt Down
D - Header Tilt Up
E - Header Down
F - Header Up
214047
23
Revision A
