16. Install pin (B) through the header leg (engaging
U-bracket in draper header support) on both sides and
secure with a hairpin (A).
17. Raise header stand (D) to storage position by pulling
spring pin (C) and lifting stand into uppermost position.
Release spring pin.
Figure 3.23: Header Leg
18. Disengage
safety
prop
by
turning
lever
(A)
downward to raise safety prop until lever locks into
vertical position.
NOTE:
If safety prop will not disengage, raise header to
release the prop.
19. Repeat for opposite side.
Figure 3.24: Cylinder Safety Prop
CAUTION
Check to be sure all bystanders have cleared the area.
20. Start engine and press HEADER DOWN switch (A) on
GSL to fully lower header.
Figure 3.25: Ground Speed Lever
21. Stop engine and remove key from ignition.
214047
26
Revision A
