UNLOADING AND ASSEMBLY
169558
Revision
D
33
STEP 12. PROGRAM CAB
DISPLAY MODULE (CDM)
The monitoring system requires programming
for each header, and the
HEADER MUST BE
ATTACHED TO THE WINDROWER.
Programming the system may be accomplished
with or without the engine running.
•
IF
ENGINE
IS
RUNNING
, the
transmission must be in NEUTRAL.
•
IF ENGINE IS NOT RUNNING
, the
ignition must be ON.
Exit Programming Mode at any time by pressing
PROGRAM switch, or by turning the ignition
OFF.
The system only needs to be programmed once
for each header. The Operator may make
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine.
Most functions have been pre-programmed at
the factory, but can be changed by the Operator
if required.
Proceed as follows to program the CDM:
a. Turn ignition key to RUN, or start the engine.
See STEP 13J. III. START ENGINE on page 43.
b. Press PROGRAM and SELECT on CDM to
enter Programming Mode.
c. Press SELECT. TRACTOR SETUP? is
displayed on upper line.
d. Press and then SELECT.
e. HEADER TYPE? is displayed. DRAPER is
flashing on lower line.
f.
Press or to change value on lower
line.
g. Press SELECT.
h. TILT CYL INSTALLED? is displayed.
i.
Press or to change value on lower
line.
j. Press SELECT to advance to the next L1 item
and press arrow keys to change values.
k. Press PROGRAM to exit Programming Mode
when finished entering desired values.
Refer to Detailed Programming Instructions on
following pages.
NOTE
Contact the manufacturer for
information regarding software
updates to the electronic modules.
*
Fast scroll applies only when changing OVERLOAD SPEED (with expansion module), and TIRE SIZE.
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
MENU ITEM SCROLL FORWARD
Displays Value Under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line - Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor Into Program
Mode With
PROGRAM
Switch
Press to Accept Menu Item and
Advance to Next Item.
SIDE DISPLAY
Displays Software Revision Status
Upper Line - C### (CDM)
Lower Line - M### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing
SELECT
Switch.
Press To Exit Program Mode.
