215981
85
Revision A
1029808
A
Figure 5.10: Safety Prop Lever
18. Engage the safety props on both lift cylinders as follows:
a.
Pull lever (A) toward you to release it, and then rotate
it toward the header to lower the safety prop onto the
cylinder.
b.
Repeat the previous step for the opposite lift cylinder.
IMPORTANT:
Ensure that the safety props engage over the cylinder piston
rods. If the safety prop does
NOT
engage properly, raise the
header until the safety prop fits over the rod.
1000711
A
Figure 5.11: Header Support
19. Install clevis pin (A) through the support and the foot, and
secure it with a hairpin. Repeat this step for the opposite
support.
IMPORTANT:
Ensure that clevis pin (A) is fully inserted into the support
and foot holes, and that the hairpin is installed behind the
bracket.
1000783
A
B
Figure 5.12: Header Stand
20. Remove the lynch pin from clevis pin (A) in stand (B).
21. Hold stand (B) and remove pin (A).
22. Move the stand to its storage position by inverting it and
positioning it onto the bracket as shown. Reinsert clevis
pin (A) and secure it with the lynch pin.
