215981
18
Revision A
3.2
Installing Caster Wheels
The windrower
’
s caster wheels may not have been installed at the factory. They will need to be installed now.
If the caster wheels are already installed, proceed to
3.3 Installing Drive Wheels, page 20
.
1022761
A
Figure 3.4: Windrower Toolbox
1.
Retrieve toolbox (A) from the storage compartment.
Remove the banding from the toolbox.
NOTE:
Use the ignition key to unlock the storage compartment.
2.
Retrieve the caster wheel hardware from toolbox (A).
1018731
A
Figure 3.5: Walking Beam Secured to Frame
3.
Remove banding and blocking (A) securing the walking
beam to the frame.
4.
Retrieve the caster wheel assemblies.
1022864
A
Figure 3.6: Lifting Windrower
5.
Have a forklift approach the front of the windrower. Slide
the forks under the frame.
IMPORTANT:
Ensure that the forks do
NOT
contact fuel tank (A). Ensure
that the forks lift
ONLY
the windrower
’
s frame.
6.
Raise the windrower approximately 152 cm (60 in.) off of
the ground. Place suitable stands under the drive wheel
legs and the rear frame. Lower the windrower onto the
stands so that the forklift
’
s forks are partially unloaded.
