215981
31
Revision A
3.8
Positioning Mirror Arms
The mirror/light support arms must be moved from the shipping position to the working position.
1014676
A
B
1014676
A
B
C
1014676
A
B
C
1014676
A
B
C
Figure 3.34: Mirror Arm in Shipping Position
1.
Locate the mirror on the left cab-forward side of the
windrower cab.
2.
Loosen retaining nut (A) and pivot nut (B) on support
arm (C).
3.
Swivel support arm (C) cab-forward by 90°.
IMPORTANT:
Do
NOT
allow the wiring harness to get caught in the swivel
mechanism.
1014674
A
B
Figure 3.35: Mirror Arm in Working Position
4.
Tighten retaining nut (A) to 39 Nm (29 lbf·ft).
5.
Tighten pivot nut (B) to 26 Nm (19 lbf·ft).
1019966
A
B
C
D
E
Figure 3.36: Roof Harness and Mirror Harness Secured
6.
To prevent wires from being pinched, ensure that roof
harness (A) and power mirror harness (B) (if these are
installed) are secured as follows:
•
Roof harness (A) to the supports with cable ties (C)
•
Mirror harness (B) (if installed) to roof harness (A) with
cable tie (D)
•
Mirror harness (B) (if installed) to the mirror arm tube
with cable tie (E)
7.
Repeat Steps
to
to reposition the
right cab-forward mirror.
