215922
167
Revision A
Attaching D1X or D1XL Series Draper Header
The windrower may have an optional self-aligning hydraulic center-link, which allows control over the vertical position of
the center-link from the cab.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
NOTE:
Draper header supports must be installed onto the windrower lift linkage before starting this procedure. For instructions,
refer to
Attaching Draper Header Supports, page 166
1.
Shut down the engine, and remove the key from the ignition.
2.
Extend the windrower transport into field mode. Refer to
1016889
A
B
Figure 4.100: Center-Link without Self-Alignment
3.
Windrowers without the self-aligning center-link kit:
Relocate pin (A) in the frame linkage as required to raise
center-link (B) until the hook is above the attachment pin
on the header.
IMPORTANT:
Ensure that the center-link is positioned high enough that it
does not contact the header as the windrower approaches
the header.
1034186
A
Figure 4.101: Left Signal Light Placard
4.
Rotate left signal light placard (A) to the up (vertical)
position before connecting the windrower to a header.
