215627
54
Revision A
7.
Center the steering wheel. Place the GSL in NEUTRAL but not in PARK. Try starting the engine to confirm that the HPT
displays MOVE GSL INTO PARK. The engine should
NOT
turn over. If the engine turns over, the safety system requires
adjustment. Refer to the windrower
’
s technical manual for the adjustment procedures.
8.
With the engine off, center the steering wheel. Place the GSL in PARK and ensure that the operator
’
s station is
NOT
locked. Try starting the engine and confirm that the engine does
NOT
turn over, and the HPT displays LOCK SEAT BASE.
If the engine starts, the safety system requires adjustment. Refer to the windrower
’
s technical manual for the
adjustment procedures.
4.1.11
Checking and Adding Wheel Drive Lubricant
–
10 Bolt Wheels
Make sure the wheel drive lubricant level is correct to maximize the service life of the components.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
CAUTION
Park on a flat, level surface with the header on the ground, the ground speed lever (GSL) in the PARK position, and the
steering wheel in the locked position (centered). To confirm that the parking brake is engaged, wait for the HPT to beep
and display a red P symbol .
The following procedure applies to windrowers equipped with 10-bolt drive wheels. If the windrower is equipped with the
optional high torque power wheels, which are secured to the windrower with 12 bolts, refer to
.
1.
Park the windrower on level ground.
$
%
&
Figure 4.25: Drive Wheel Hub
2.
Position the windrower so that plugs (A) and (B) are
horizontally aligned with center (C) of the hub.
3.
Shut down the engine, and remove the key from
the ignition.
4.
Remove plug (A) or (B). The lubricant should be visible
through the port. Some fluid may spill from the port.
5.
If necessary, add lubricant until lubricant runs out from
open port (A) or (B). For lubricant specifications, refer to
6.1 Lubricants, Fluids, and System Capacities, page 145
.
IMPORTANT:
The lubricant used for the first wheel drive lubricant change
differs from the type of lubricant used at the factory. For
lubricant specifications, refer to
6.
Reinstall the plugs and tighten them to 24 Nm (18 lbf·ft).
