215627
101
Revision A
$
Figure 5.70: HPT Display
23. Press soft key 3 (A) to restore the header float.
NOTE:
If the header float is active, the icon at soft key 3 displays
Remove Float; if the header float has been removed, the
icon displays Resume Float.
24. Shut down the engine, and remove the key from
the ignition.
5.3.3
Connecting R113 Rotary Disc Header Hydraulics and Electrical to Windrower
The procedure for connecting the R113
’
s hydraulic and electrical systems to the windrower differs depending on the
configuration of the windrower.
IMPORTANT:
Before connecting the hydraulics from an R113 Rotary Disc Header to an M1240 Windrower, first install the M1240 Low
Pressure Case Drain kit (MD #B6698) by following the instructions provided included with the kit.
The procedure for connecting the R113
’
s hydraulic connections to the windrower depends on the windrower
’
s
configuration:
•
Auger/rotary disc/draper header-ready windrowers are equipped with a set of hydraulic quick couplers which are
compatible with the header drive hoses on the rotary disc header.
•
Rotary disc header-ready windrowers are equipped with hard-plumbed hydraulic connections.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all hydraulic couplers.
NOTE:
The R113 Rotary Disc Header hydraulic bundle includes a complete set of quick couplers that can be installed onto a rotary
disc header-configured windrower.
$
%
Figure 5.71: Left Cab-Forward Platform
1.
Approach platform (A) on the left cab-forward side of the
windrower and ensure the cab door is closed.
2.
Push latch (B), and pull platform (A) toward the walking
beam until it stops and the latch engages.
