OPERATION
Form 169216
January 2009
16
To adjust deck angle:
The deck angle relative to the right hand drive
tire is adjustable with turnbuckle (Q). A distance
of 100 mm (4”) from the deck to the tire is
recommended. To adjust the turnbuckle, loosen
the locking tab and rotate center tube to desired
length then re-lock tab against tube.
NOTE:
If setup with an R80 header, the deck
will only be in its most forward position when the
tractor is running. The lift cylinder is single
acting so it is not pressurized in the down stroke
when the tractor is shut off. When the tractor is
running there is a supply of low pressure oil to
move the deck forward.
The deck angle relative to the ground should be
horizontal or at a slight incline. Distance (C)
should be equal to or greater than (D). If used
with an R80 header in lighter crop, distance (C)
should be equal to (D). If the crop needs to be
thrown farther, increase distance (C).
To adjust the deck angle loosen four ¾” bolts (E)
and then loosen nut (F). Adjust draw bolt by
tightening the second nut (F) if you want to
increase distance (C) and loosen nut if you want
to decrease distance (C). Once done adjusting,
tighten nut (F) and then tighten four bolts (E).
The four ¾” bolts must be torqued to 245 ft-lbs.
100 mm or 4”
DECK ANGLE TO GROUND
C
D
A30/40 & D60
R80
Q
DECK ANGLE TO TIRE
E
E
F
Summary of Contents for M150 2009
