HEADER OPERATION – R SERIES
Form 169469/169470/169471
118
Revision C
6.7.3 DISC SPEED
The header is allocated a code that the WCM
reads when the header is first attached to the
windrower, and the disc speed set-point
automatically becomes the minimum disc speed
for the header. The operator can then program
the desired speed from the following table on the
CDM to be stored in the WCM memory so that if
the header is detached and then re-attached to
the windrower, the disc will operate at the
original set-point.
CROP
CONDITION
DISC RPM *
Alfalfa
Heavy
2100-
2300
Light
1800-
2000
Sudan,
Sorghum,
Haygrazer,
Timothy
Tall &
Stemmy
2300-
2500
Short Grass
Dense
2500
Thin
2000-
2200
* Suggested Overload Setting – 1300 rpm.
NOTE
Higher engine rpm may be required to
engage the R85 headers. Do not exceed
1800 rpm.
NOTE
Desired disc speed will only be maintained
above 1500 rpm (engine). Disc speed is
not adjustable below this rpm.
Display and set the desired disc speed as
follows:
CAUTION
Check to be sure all bystanders have cleared
the area.
XXX0 = RPM
ENGAGE HEADER
HEADER INDEX
SWITCH -
OFF
ON GSL PRESS
FAST
OR
SLOW
DISPLAY SHOWS
XXX0 DISC RPM
DONE
SPEED
O.K.?
NO
YES
DISPLAY
SELECTOR
DISPLAY
HEADER INDEX
FAST
SLOW
Summary of Contents for M205 2010
Page 1: ...M205 Self Propelled Windrower OPERATOR S MANUAL Revision C Part 169469 25...
Page 51: ...OPERATOR S STATION Form 169469 169470 169471 49 Revision C continued next page...
Page 95: ...HEADER OPERATION D SERIES Form 169469 169470 169471 93 Revision C continued next page...
Page 181: ...MAINTENANCE SERVICE Form 169469 169470 169471 179 Revision C 7 10 13 3 Fuse Box Decal...
