MAINTENANCE/SERVICE
Form 169469/169470/169471
124
Revision C
7.4 ENGINE COMPARTMENT HOOD
The engine hood has two open positions. The
lowest is for general maintenance such as
checking and adding fluid, servicing the cooling
box, etc. The highest position accommodates
full access to the engine bay
a. Open the hood at the lowest position as follows:
1. Locate latch (A) behind grill and lift to
release hood.
2. Raise hood until strap (B), which should be
looped under hooks (C) and (D), stops it at
approximately a 40° angle.
3. Remove strap from hook (C) and allow hood
to raise slightly further.
b. To close hood:
1. Grasp the strap at (B) and loop under upper
hook (C).
IMPORTANT
Failure to hook strap may result in it
becoming entangled with the screen
cleaners or the latch.
2. Pull down on strap (B), grasp the hood when
within reach and lower until hood engages
latch (A).
c. Open the hood at the highest position as follows:
1. Open hood to lowest position.
2. Remove strap from hooks (C) and (D) and
allow hood to raise fully to approximately 65°
d. To close hood:
1. Grasp the strap at (B) and loop under upper
hook (C).
2. Pull down on strap and loop under lower
hook (D).
IMPORTANT
Failure to hook strap may result in it
becoming entangled with the screen
cleaners or the latch.
3. Pull down on strap, grasp the hood when
within reach and lower until hood engages
latch (A).
B
A
D
C
B
C
D
A
Summary of Contents for M205 2010
Page 1: ...M205 Self Propelled Windrower OPERATOR S MANUAL Revision C Part 169469 25...
Page 51: ...OPERATOR S STATION Form 169469 169470 169471 49 Revision C continued next page...
Page 95: ...HEADER OPERATION D SERIES Form 169469 169470 169471 93 Revision C continued next page...
Page 181: ...MAINTENANCE SERVICE Form 169469 169470 169471 179 Revision C 7 10 13 3 Fuse Box Decal...
