HEADER – GENERAL
Form 169469/169470/169471
88
Revision C
6.4.6 CUTTING HEIGHT
The header is raised or lowered with the
HEADER UP or HEADER DOWN switches on
the GSL. See illustration. The CDM indicates
the header height by a reading on the DISPLAY
lower line between 00.0 and 10.0, with 00.0
being on the ground. Use DISPLAY
SELECTOR switch to display the current setting.
6.4.6.1 Return to Cut
The M Series monitoring system will assist the
operator in maintaining the desired cutting
height with the RETURN TO CUT feature that
can be turned off or on with a switch on the
CDM.
The RETURN TO CUT feature enables the
operator to have the header return to a pre-
selected cutting height and angle. If desired, the
CDM can be programmed so that only the
cutting height feature is active. The unit is pre-
programmed to activate both cutting height and
header angle.
The AUTO RAISE HEIGHT feature allows the
operator to raise the header to a pre-selected
height while in the RETURN TO CUT mode.
See Section 6.4.6.2 Auto-Raise Height.
a. Program the RETURN TO CUT feature as
follows:
IMPORTANT
The windrower must be running with the
header engaged.
1. RETURN TO CUT switch must be off
(indicator light is off).
2. Adjust the header to the desired cutting
height with the HEADER UP or HEADER
DOWN switches on the GSL. CDM displays
between
00.0 and 10.0
.
3. Adjust the header angle with the HEADER
TILT UP or HEADER TILT DOWN switches
on the GSL. CDM displays between
.0 and
10.0
. This step is not required if height only
has been pre-selected.
4. Press the RETURN TO CUT switch on the
CDM. The indicator light will illuminate and
the settings are now programmed into the
WCM.
b. Use the RETURN TO CUT feature as follows:
IMPORTANT
Ensure the header is engaged and the
RETURN TO CUT switch is illuminated.
NOTE
The header can be raised or lowered at
any time by
depressing and holding the
HEADER UP or HEADER DOWN
switches on the GSL.
1. If header is above the pre-set cutting height,
momentarily press
HEADER DOWN
switch and header will return to pre-set
height.
(continued next page)
HEADER DOWN
DISPLAY
SELECTOR
DISPLAY
HEADER UP
HEADER
TILT UP
HEADER
TILT DOWN
HEADER DOWN
RETURN TO
CUT
DISPLAY
HEADER UP
Summary of Contents for M205 2010
Page 1: ...M205 Self Propelled Windrower OPERATOR S MANUAL Revision C Part 169469 25...
Page 51: ...OPERATOR S STATION Form 169469 169470 169471 49 Revision C continued next page...
Page 95: ...HEADER OPERATION D SERIES Form 169469 169470 169471 93 Revision C continued next page...
Page 181: ...MAINTENANCE SERVICE Form 169469 169470 169471 179 Revision C 7 10 13 3 Fuse Box Decal...
