262391
92
Revision A
1020992
A
B
Figure 4.25: Left Endsheet
9.
Install four bolts, large washers, and nuts (A) to secure
outboard curtain (B) to the endsheet. Torque the bolts to
39 Nm (29 lbf·ft).
NOTE:
R1 SP for windrowers shown in the illustration; R1 FR
similar.
4.4.3
Lubricating Cutterbar
Correct lubricant and levels are essential to the performance and longevity of the cutterbar.
Checking and Adding Lubricant
–
Cutterbar
Correct lubricant and levels are essential to the performance and longevity of the cutterbar.
DANGER
To prevent injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and remove
the key from the ignition before leaving the operator
’
s seat or making adjustments to the machine. If the rotary disc
header is raised, always close the lock-out valves, and place blocks under the header. Never work on or beneath an
unsupported header.
DANGER
Ensure that all bystanders have cleared the area.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Park the machine on a flat, level surface.
2.
Shut down the engine, and remove the key from the ignition.
3.
Place blocks under each end, or just inside each end, of the cutterbar.
4.
Lower the onto the blocks.
5.
Shut down the engine, and remove the key from the ignition.
6.
Open the cutterbar doors. For instructions, refer to
