262391
46
Revision A
ϭϬϰϯϳϮϳ
A
B
Figure 3.36: Float Indicator
–
Left Side
11. With the header on level ground in cutting position,
calibrate float indicator (A) by loosening jam nut (B), and
turning the adjustable rod until the needle is centered on
the number
“
2
”
.
3.13.3
Cutting Height
The cutting height is determined by a combination of the cutterbar angle and the skid shoe settings. Adjust the cutting
height for optimum cutting performance while preventing the excessive build-up of mud and soil inside the rotary disc
header, which can lead to poor crop flow and increased wear on cutting components.
Lowering the skid shoes and decreasing the cutterbar angle increases the cutting height, resulting in higher stubble that
helps material dry faster. This may be desirable in stony conditions to help reduce damage to cutting components.
Raising the skid shoes and increasing the cutterbar angle decreases the cutting height, resulting in a shorter stubble. For
instructions, refer to
Adjusting Cutting Height, page 46
.
To choose a cutterbar angle that maximizes performance for your crop and field conditions, refer to
.
To minimize cutterbar damage, scooping soil, and soil build-up at the cutterbar in damp conditions, the float should be set
as light as possible without causing excessive bouncing. For instructions, refer to
.
Adjusting Cutting Height
Lowering the skid shoes and decreasing the cutterbar angle increases the cutting height, resulting in taller stubble that
helps material dry faster. Raising the skid shoes and increasing the cutterbar angle decreases the cutting height, resulting in
shorter stubble.
DANGER
Ensure that all bystanders have cleared the area.
NOTE:
There are two skid shoes on the R113 FR and four on the R116 FR.
1.
Position the rotary disc header at an appropriate height for the task.
2.
Shut down the engine, and remove the key from the ignition.
