215585
101
Revision A
5.3
Attaching Rotary Disc Pull-Type to the Tractor
Refer to the attachment procedure that applies to your tractor:
•
5.3.1 Attaching with Drawbar Hitch, page 101
•
5.3.2 Attaching with Two-Point Hitch, page 103
5.3.1
Attaching with Drawbar Hitch
If the pull-type was configured for a tractor with a drawbar hitch, and the tractor
’
s hitch has been adjusted correctly, then
the pull-type can now be attached to the tractor.
DANGER
To avoid bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key before making adjustments to the machine.
1.
Shut down the engine, and remove the key from
the ignition.
$
%
Figure 5.3: Rotary Disc Pull-Type Hitch
2.
Remove lynch pin (A) from clevis pin (B), and remove the
clevis pin from the rotary disc pull-type hitch.
DANGER
Never start or move the machine until you are sure all
bystanders have cleared the area.
$
%
Figure 5.4: Rotary Disc Pull-Type Hitch
3.
Move the tractor to position drawbar hitch adapter (A)
under pin (B) in the hitch. Adjust height as necessary
with jack.
