215585
115
Revision A
6.4
Setting up Forming Shields
Each type of conditioner uses a different configuration for the swath forming shield. Refer to the applicable instruction for
the conditioner supplied with the machine.
If a finger conditioner is installed, refer to
6.4.1 Setting up Forming Shields for Finger Conditioner, page 115
.
If a roll conditioner is installed, refer to
6.4.2 Setting up Forming Shields for Roll Conditioner, page 120
.
If no conditioner is installed, refer to
.
6.4.1
Setting up Forming Shields for Finger Conditioner
On a machine equipped with a finger conditioner, the shields provide an enclosure for the fingers to flail the crop and
control distribution onto the field.
NOTE:
Transport not shown in illustrations for clarity.
$
%
$
$
Figure 6.13: Forming Shields Strapped to Pallet
1.
Before setting up the forming shields, convert the header
to field mode. For instructions, refer to
.
2.
Remove shipping wires (A) securing forming shield
covers (B) to pallet.
$
%
&
Figure 6.14: Outboard Top Cover
3.
Support shield (C), remove two bolts at
locations (A) and (B), and remove the shield.
