20
Wireless AP can’t connect with AP
(the status display unconnected)
Try to scan the avaliable wireless
networking again;
Make sure the Wireless AP’s wire-
less standard is correct;
(2.4Ghz signal should connect
2.4Ghz, 5.8Ghz signal should con-
nect 5.8Ghz signal);
The Security and passwords are
matched between Wireless AP
and AP;
The signal strength of AP is too
weak to connect, should be more
than -75dBm;
Can’t scan the wireless AP
Scan it several times more;
If using 5Ghz to scan, please
make sure there are 5G signal
existed.
Reset the Wireless AP, scan it
again after Wireless AP restart;
The connection of Wireless AP
and AP is success, but the com-
puter can’t share internet
Pls Check the computer’s IP
address and DNS setting. If it is
dynamin, set the network card as
automatically obtain. If it is static
IP, pls contact with ISP for correct
IP address and DNS address.
How to Reset Wireless AP
Press the “Reset” button more
than 15 seconds after power on.
The Wireless AP will restore fac-
tory default after the Wireless AP
restart.
