52 INSTRUMENTS AND CONTROLS
15. Engine Shutdown Indicator (Red)
– Indicates the occurrence of a condition
which requires that the engine be shut down (i.e., low water level, low oil pressure
or high water temperature). If the engine shutdown feature is enabled, the engine
will be forced to idle. Once vehicle is stopped, the engine will shut down. If the
engine shutdown feature is disabled, the indicator will function as a warning light but
the engine will not shut down.
16. Air Suspension Low Indicator (Amber) (DPF)
16. Aftertreatment DEF Low Level Indicator (DEF) (SCR)
– Icon illuminated
when the fluid level is low. It also flashes when the level becomes critically low.
17. Anti-Lock Brake System (ABS) Indicator (Amber)
– Indicates an ABS
malfunction. If the light turns on and stays on, a malfunction is indicated. For
additional information on operating an ABS-equipped vehicle, refer to “Anti-Lock
Brake System (ABS)”, page 120of the
Operation
section.
Note:
When an ABS malfunction is detected, anti-lock braking in the affected wheel(s) will
be disabled and normal braking will return; the other wheels will retain anti-lock braking.
Operate the vehicle normally and have the ABS system serviced to correct the fault.
18. Low Coolant Level Indicator (Amber)
– Illuminates when the coolant level
in the coolant surge tank is below the specified level. Stop and add coolant. Use
typical warnings, etc., for filling coolant.
19. CO-PILOT®
– Co-Pilot® is an in-dash computer that allows the vehicle operator
to monitor information supplied by the V-MAC® electronic control system. The
Co-Pilot® enhances the functions of V-MAC® by entering requested information
with the stalk switch. The Co-Pilot® is very "user friendly" and prompts the operator
with messages on the display screen. For more information on how to use the
Co-Pilot®, please consult the
V-MAC® IV Vehicle Management and Control with
Co-Pilot® Display Operator’s Guide.
20. Water in Fuel Indicator (Amber) (If Equipped)
– Illuminates when water
accumulates in the primary fuel filter sediment bowl. Stop the engine and drain the
fuel from the sediment bowl.
21. Engine Over Speed Indicator (Red)
– Illuminates when maximum engine
RPM is exceeded.
22. Trailer Anti-Lock Brake System (ABS) Indicator (Amber)
– Indicates an
ABS malfunction. If the light turns on and stays on, a malfunction is indicated. For
additional information on operating an ABS-equipped vehicle, refer to “Anti-Lock
Brake System (ABS)”, page 120of the
Operation
section.
Note:
When an ABS malfunction is detected, anti-lock braking in the affected wheel(s) will
be disabled and normal braking will return; the other wheels will retain anti-lock braking.
Operate the vehicle normally and have the ABS system serviced to correct the fault.
23. Cruise Control Indicator (Green)
– Indicates that cruise control is engaged.
Summary of Contents for CHM 2010
