89
Owner's Manual
Owner
's Manual
9. Insert a blank CD ROM into your computer’s CD drive or other attached CD Burner.
10. Open whatever CD burning software you use to create CDs from your PC, and burn all the contents of
the “Digital X Bus Update” folder (or whatever you named it) directly to the CD. Make sure you fi nalize
the CD so it can be read by other computers.
11. Remove the CD from your computer or attached CD drive and insert it into the USB CD ROM drive at-
tached to your Digital X Bus.
12. Select “Install Packages” from the File Menu on the Digital X Bus.
13. Select the new build to be installed from the list and select “Run Installer.” Select “OK” when asked to
shut down the Digital X Bus application in order to run the Installer.
14. Once you are back to the main mixer screen, re-select the “Install Packages” from the File Menu.
15. If there is a “System Update” fi le in the list and the Status column reads “Needs Update,” then high-
light the “System Update” fi le and select “Install.” But if the Status column reads “Up to Date,” then
move on to Step #17.
16. Re-boot the console. If it re-boots itself, then move on to Step #17.
17. Once you are back to the main mixer screen, select “About” from the Windows menu and verify you are
running the same number build you just downloaded.
Windows 2000/ME/98SE Users
The procedure for Windows 2000/ME/98SE is identical to the procedure for Windows XP, with the only
exception being the need to have the WinZip Utility Program installed. WinZip can be downloaded either as
a demo version (free) or a commercial version (charge) from
www.winzip.com
and installed on your PC.
USB Flash/Pen Drive Method (recommended)
***Requires a USB Flash/Pen drive with the appropriate drivers for Windows 2000/ME/98SE***
1. Download the Digital X Bus software update from
www.mackie.com
to your local hard drive.
2. Insert a USB Flash Drive into your computer. You may have to install special drivers to interface your
PC with your USB Flash drive…see the USB Flash Drive product documentation for more information.
3. Double-click on the fi le you just downloaded, which should open the WinZip Utility.
4. Highlight
all
fi les displayed in the WinZip window, and select “Extract.”
5. Browse to the base level, “root” directory of the USB Flash Drive and select “OK.”
Note:
Make sure the WinZip utility does not create a master folder on your Flash Drive…if it does,
then cut the fi les from that master folder and paste them all to the root directory.
6. Remove the Flash Drive from your computer and insert it into one of the available USB ports on your
Digital X Bus.
7. Select
“Install Packages” from the File Menu on the Digital X Bus.
8. Select the new build to be installed from the list and select “Run Installer.” Select “OK” when asked to
shut down the Digital X Bus application in order to run the Installer.
9. Once you are back to the main mixer screen, re-select the “Install Packages” from the File Menu.
10. If there is a “System Update” fi le in the list and the Status column reads “Needs Update,” then high-
light the “System Update” fi le and select “Install.” But if the Status column reads “Up to Date,” then
move on to Step #12.
11. Re-boot the console. If it re-boots itself, then move on to Step #12.
12. Once you are back to the main mixer screen, select “About” from the Windows menu and verify you are
running the same number build you just downloaded.
Summary of Contents for X.200
