90
X.200
Digital X Bus
CD ROM Method
***Requires a CD burner attached to your PC as well as a USB CD ROM drive attached to the Digital X Bus***
1. Make sure you have a CD Burner and the appropriate software loaded on your computer.
2. Download the Software update from
www.mackie.com
to your local hard drive.
3. Create a new folder on your desktop and label it “Digital X Bus Update.”
4. Double-click on the fi le you just downloaded, which should launch the WinZip Utility.
5. Highlight
all
fi les displayed in the WinZip window, and select “Extract.”
6. Point the WinZip Extractor to the new “Digital X Bus Update” folder on your desktop and Click “OK.”
7. Once the Extraction is completed, close the WinZip utility.
8. Insert a blank CD ROM into your computer’s CD drive or other attached CD Burner.
9. Open whatever CD burning software you use to create CDs from your PC, and burn all the contents of
the “Digital X Bus Update” folder (or whatever you named it) directly to the CD. Make sure you fi nalize
the CD so it can be read by other computers.
10. Remove the CD from your computer or attached CD drive and insert it into the USB CD ROM drive at-
tached to your Digital X Bus.
11. Select “Install Packages” from the File Menu on the Digital X Bus.
12. Select the new build to be installed from the list and select “Run Installer.” Select “OK” when asked to
shut down the Digital X Bus application in order to run the Installer.
13. Once you are back to the main mixer screen, re-select the “Install Packages” from the File Menu.
14. If there is a “System Update” fi le in the list and the Status column reads “Needs Update,” then high-
light the “System Update” fi le and select “Install.” But if the Status column reads “Up to Date,” then
move on to Step #16.
15. Re-boot the console. If it re-boots itself, then move on to Step #16.
16. Once you are back to the main mixer screen, select “About” from the Windows menu and verify you are
running the same number build you just downloaded.
Mac OS X Users
USB Flash/Pen Drive (recommended)
***Requires a USB Flash/Pen drive***
1. Insert a USB Flash Drive into your Mac so you can see the icon of that drive on your desktop.
2. Download the Software update from
www.mackie.com
to your desktop.
3. Double-click on the .zip fi le to create a folder on your desktop labeled after the build version you just
downloaded.
4. Open that same folder so you can see all the contents and fi les.
5. Drag all the contents of that same folder onto the icon of your Flash Drive.
6. Remove the Flash Drive from your computer and insert it into one of the available USB ports on your
Digital X Bus.
5. Select
“Install Packages” from the File Menu on the Digital X Bus.
6. Select the new build to be installed from the list and select “Run Installer.” Select “OK” when asked to
shut down the Digital X Bus application in order to run the Installer.
7. Once you are back to the main mixer screen, re-select the “Install Packages” from the File Menu.
Summary of Contents for X.200
