995086
–
Rev B
Page 7 of 32
4 . 9
Lift Tape
•
Inspect the full length of the lift tape for any fraying or damage to the materials integrity.
•
Ensure that the stitching remains in good condition, there should be no sign of any loose threads or
fraying by the bindings, this should be checked at both ends of the lift tape.
•
Ensure that the lift tape label remains legible.
4 . 10
Limit Switches
•
Ensure that the limit switches remain functional.
•
Test the bottom limit switch activates by fully lowering the lift tape out of the hub during normal use.
•
Test that the bottom limit switch activates when the carry bar is removed from the portable lift.
•
Test the upper limit switch activates by raising the lift tape all the way up to the top limit.
•
Inspect the limit switch wires and solder points for any damage and exposed wire. Make sure to check
inside the chassis as the cable runs inside.
4 . 11
PCB (Printed Circuit Board)
•
Inspect the PCB for any damage such as cracks and electrical burns.
•
Ensure that all the relevant components are plugged into the board correctly.
•
Inspect the wiring for each component that plugs into the PCB. Ensure there are no exposed wiring.
4 . 12
LED Indicator (Membrane)
•
Ensure that the buttons remain functional on the membrane.
•
Test LED is functioning correctly, ensure that the LED is indicating the correct light for each scenario
(where applicable)
4 . 13
Charging
•
Inspect the condition of the charging unit, ensure that the casing remains intact and there is no cuts or
exposed wires.
•
Inspect the condition of the charging dock (handset case), ensure that the jack plug remains fixed into
the case and the handset docks correctly into the plug.
4 . 14
Fixings
•
Inspect all the main nuts, bolts, screws and other fixings are secure and tight, if any fixings are loose
ensure to tighten accordingly.
