SA160E User Manual Rev 3 - Aug 2016
Page 18
7.0 Fault Finding / Maintenance
7.1 Fault Finding
If the hoist will not operate:-
ENSURE THE BATTERY IS CHARGED AND THAT IT IS
ATTACHED CORRECTLY TO THE CONTROL BOX
ENSURE THAT STOP BUTTON IS IN THE OUT POSITION.
MAKE SURE THE CHARGING LEAD IS DISCONECTED FROM
THE MAINS POWER SUPPLY
CHECK THE HANDSET LEAD HAS NOT BEEN PULLED
FROM THE CONTROL BOX SOCKET OR WIRES DAMAGED
If the above checks prove unsuccessful, contact your nearest
MACKWORTH APPROVED AGENT
7.2 Service / Maintenance
Any work performed on the SA160E must be in accordance with the
specifications detailed in the test requirements of BS 10535:2006.
You should also consider if the hoist requires servicing in accordance
with “LOLER REGULATIONS” (Lifting Operations and Lifting Equipment
Regulations 1998).
7.3 Cleaning, Disinfection and Sterilisation
The SA160 E has an anti-microbial coating. This does not replace the
need to clean and maintain the hoist unit.
Routine cleaning:
the exterior of the stand aid can be wiped over
with a damp cloth containing a mild soap solution.
Disinfection and Sterilisation:
the exterior of the stand aid should
only be disinfected and sterilised using Isopropyl alcohol. Dampen a
cloth with isopropyl alcohol and wipe down the entire stand aid.
DO NOT USE ABRASIVE MATERIALS
DO NOT IMMERSE THE HOIST UNIT.
