999674 – Revision B
P a g e
|
36 of 44
Check the carry bar rotates and swings freely, and that there is no build-up of
wear.
Ensure the Spring Clips on the Carry Bar are functional and present.
Lift Tape
Inspect the Hoist Lift Tape for any signs of damage such as fraying, breaking and
tearing along its entire length. Ensure to also inspect the stitching on the tape for
the same signs of damage.
QRS (Quick Release Hook)
Ensure that the locking device on the QRS is closed when the carry bar is attached.
Inspect the QRS for damage such as cracking. And ensure that the locking device is
functioning correctly.
LED’s
Ensure that the LED’s are all working correctly prior to use.
LCD Display Screen
Ensure that the LCD is working correctly and the messages can be read.
Wheels
Ensure the wheels are traversing smoothly in the track before traversing a patient
along the system. Listen for any unusual noises.
Motor
When raising and lowering the Hoist, with or without load, listen to the motor for
any unusual lifting noises. Lower the patient immediately if an unusual noise is
present.
Handset
Ensure the Handset is functional, ensure the connection to the Hoist is correct and
that all the buttons are working before operation with a patient.
The image (Figure 39) indicates a badly worn lift tape due to an acumination of events the Hoist has
operated under.
Whilst a tape in this condition provides no immediate danger, the Hoist should not be
used until a service agent can replace the damaged tape.
The visual checks that must be performed before each use will make the operator aware of a tape
degrading. Any damage should prompt the operator to cease use and seek a replacement.
11.3
Cleaning
Please follow the cleaning guidelines below on cleaning and disinfecting the Hoist.
It is recommended to clean the Hoist and accessories before use by a different person, reducing the risk of cross–
contamination.
The exterior of the Hoist can be cleaned using a damp soapy cloth for general cleaning duties. Please ensure the cloth is damp
and not wet. Ensure the exterior of the device is dry after cleaning. Dry using a clean dry cloth.
For the Handset and Lift Tape, use a dry cloth wipe only.
Care should always be taken when cleaning around electrical components to reduce the risk of electric shock or
damage to the Hoist.
Table 16
Figure 39
