INST-MAN12 ISSUE 5 © 2020
2
Hose Installation Procedure
Truck bed
Wall (Max 4 meter above the floor)
Ceiling (Max 4 meter above the floor)
Note: Hose must always pull straight off
the drum as pictured in fig 2 below
Guide arm positions:
Mounting Options
Fig 1
Fig 2
Fig 3
Note: Incorrect hose orientation pictured
in Fig 3 below
Remove Hose Assembly
1) Turn off and disconnect the supply to reel and
release hose line pressure.
2) Pull out approximately 2m (6ft) of hose and allow
the drum to latch.
3) Remove the outlet nozzle, gun or tool and hose
stopper. Unlatch the reel and carefully allow the
hose to slowly rewind until there is no spring tension
remaining.
4) Manually unwind the hose assembly from the
drum. Carefully disconnect and remove the hose
from swivel assembly.
Fit Hose Assembly
5) Connect your new hose assembly to the swivel
assembly.
6) Manually rotate the drum assembly (away from
the roller guides) and manually recoil the hose onto
the drum.
7) Add tension to the reel by carefully rotating the
drum and hose assembly (towards the roller guides)
4 complete turns, slide the hose through the roller
guides and allow the reel to latch.
8) Fit the hose stopper to the hose end, release pull
the hose to release the drum latch, and slowly allow
the hose to slowly rewind onto the reel.
Adjust Spring Tension
1) Allow the hose to fully retract with the hose
stopper sitting against the mouth of the reel.
2) Loosen (but do not remove) the 4 bolts located on
the side of the reel.
3) Insert M12 hex allen key and hold it firmly before
removing the 4 bolts. When the bolt is removed,
the spring tension will transfer to the hex key.
Maintenance
